Abstract
Millimeter and submillimeter wave receivers in scanning planar near-field test systems are commonly based on harmonic mixing and thus require at least one flexible microwave cable to be connected to them. The phase errors originated in these cables get multiplied and added to the phase of the final detected signal. A complete submillimeter setup with on-the-fly measurement of phase errors is presented. The novel phase error correction system is based on the use of a pilot signal to measure the phase errors caused by cable flexing. The measured phase error surface in the quiet-zone region of a 310 GHz compact antenna test range (CATR) based on a hologram is shown as an application example. The maximum measured phase error due to the cable within a 80/spl times/90 cm/sup 2/ scan area was 38/spl deg/.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
