Piezoelectric Device and Dynamic Navigation System Integration for Bone Window-Guided Surgery

Abstract

IntroductionThis study investigates the feasibility of integrating a piezoelectric device (PIEZO) into a dynamic navigation system (DNS) for bone-window guided surgery. It compares the accuracy and efficiency of PIEZO + DNS to PIEZO + Freehand (FH) procedure for bone-window cutting and root-end resection (RER). MethodsForty-eight mandibular molars of 3D-printed surgical jaw models were divided into two groups: PIEZO + DNS (n = 24) and PIEZO + FH (n = 24). Cone-beam computed tomography scans were taken before and after the procedure. The procedure was virtually planned on X-guide software. The bone-window cutting and RER were conducted with a PIEZO under dynamic navigation in the PIEZO + DNS group and using the dental operating microscope in the PIEZO + FH group. The 2D- and 3D-accuracy deviations and angular deflection were measured for the bone window cut. The root length resected and resection angle were calculated. The bone window cut, RER, total operating time, and number of mishaps were recorded. ResultsPIEZO + DNS was more accurate than PIEZO + FH for bone-window cutting, showing fewer 2D and 3D deviations and less angular deflection (P < .05). The resection angle was lower in the PIEZO + DNS (P < .05). The bone-window cut and total operating time were significantly reduced using a DNS (P < .05). There was no difference in the number of mishaps (P > .05). ConclusionsWithin the limitations of this in vitro study, the integration of a PIEZO into a DNS is feasible for bone-window guided surgery. The DNS improved the accuracy and efficiency of bone-window cutting.