Piezoelectric ceramic for energy harvesting from ambient vibration

Abstract

Direct piezoelectric conversion is very popular in generating power from mechanical stress. There is continuous progress in power harvesting from mechanical vibration. In this article, experimental tests on a piezoelectric circular plate, to evaluate the electric power produced by the piezoelectric conversion at low acceleration over a wide range of ambient vibration frequency, are presented. The experimental analysis is presented and discussed. The results demonstrate the potentiality of using low-cost piezoelectric diaphragms to harvest energy from ambient vibration. Under low acceleration (5.36 m/s2), the vibration frequency was varied in the range of 10– 200 Hz and the generated power was measured. Under a very small dynamic force (less than 0.06 N), the output power of 1.5 mW was obtained with an 8.5 mm drum harvester across a load resistance of 17.8 kΩ at a frequency of 173 Hz.