Abstract
In this research, a piezoelectric metal scanning micromirror with a large reflective surface area is presented. Unlike conventional scanning micromirrors fabricated with single-crystal silicon, stainless steel plate is used as the structural layer material. Two distinct device models, varying in cantilever and connector geometry, were conceptualized and experimentally assessed. These fabricated devices utilized the strain induced in bulk PZT (lead zirconate titanate) plates affixed to the cantilevers on opposing sides of the reflective surface. A 5 mm-diameter gold-coated silicon mirror plate served as the reflective surface. We evaluated the performance of two bulk PZT plates, PZT-5H and PZT-8. Our experimental results reveal that model #1, driven by PZT-5H with a sinusoidal input voltage of 200 Vpp, achieved a maximum optical scan angle of 26°, while model #2 exhibited a more substantial maximum scan angle of 44°. The average resonant frequency of the PZT-5H samples was 1264 Hz for model #1 and 995 Hz for model #2. These findings underscore the viability of stainless steel plates as a robust structural layer for piezoelectric scanning micromirrors. The proposed design holds potential for integration into a 3D LiDAR system when combined with an additional slow vertical scanner.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
