Abstract
In this work, a single - link flexible joint robot manipulator is constructed and controlled using various control techniques. The position and trajectory control is performed by PH) and State Feedback control methods for this system. The purpose of this study is to keep the rotate angle of the link at desired position and to eliminate the oscillation angle of end effectors. The experimental results were compared for each method. The control blocks required for the system are performed on Matlab - SIMULINK and applied dSpace 1103 control board. The experimental results of the system based on Pro and State Feedback controller are quite satisfactory.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.