Abstract
We propose a convenient brush coating method for liquid crystal (LC) alignment. This method enables film deposition and an alignment layer treatment process simultaneously. Aluminum bismuth gallium zinc oxide (AlBiGaZnO) is used as the alignment layer. After the curing process, a unidirectional AlBiGaZnO film is formed; its surface morphology and chemical composition were verified using scanning electron microscopy and X-ray photoelectron spectroscopy. This oriented structure of the surface was produced by shear-stress which originated from brush movement. That structure induced a surface anisotropic characteristic and resulted in a uniform LC alignment. The uniform and homogeneous LC alignment state on the film was confirmed using polarized optical microscopy and pre-tilt angle analysis. The brush coated AlBiGaZnO film exhibited excellent thermal budget for advanced LC system. The film exhibited enhanced electro-optical performance with a low operating voltage. These results demonstrate the potential of LC alignment technology via the brush coating method.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
