Abstract
This study aims to investigate the effect of high temperatures of up to 1200°C and rehydration on the mechanical properties, microstructure and phase composition of blended cement pastes prepared from Portland cement (PC), granulated blast furnace slag (GBFS), high-temperature fly ash (FA) and ground limestone (GL). It has been found that the heating process induces a reduction in bulk density, flexural and compressive strength. The proportion of pores with a diameter higher than 0.1μm increases with increasing temperature. The addition of GBFS or FA improves the strength properties of dehydrated cement paste (DCP), but this effect was not observed after rehydration. Cement paste with added GBFS has the best resistivity to high temperatures, but after rehydration, GL cement paste shows better mechanical properties.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
