Physical Simulation of the Hot Direct Rolling of Steel

Abstract

Thin slab casting and direct rolling technologies became important for hot strip production to increase the productivity, to lower the investment costs and to increase the energy efficiency. The main objective of our investigation is to gain a better understanding of the microstructural evolution starting from solidification through to the final hot rolled sheet. Small ingots were cast and direct rolled and reheated and rolled, using a thermomechanical testing machine. The differences in the recrystallization kinetics during both production routes were measured using double hit hot compression tests. In addition, multipass deformation trials were performed to reveal differences in the resulting microstructure and the grain size homogeneity. It was found, that the coarse initial microstructure before rolling become negligible after three rolling passes. This means that despite the simple and economical direct rolling similar mechanical strip properties can be obtained in comparison to conventional strip production routes.