Physical Properties of Gelatin Films Plasticized by Blends of Glycerol and Sorbitol

Abstract

The addition of plasticizers increases the flexibility and workability of films based on biopolymers. However, the use of some plasticizers cause undesirable results, such as the migration of these additives out the film or crystallization during shelf life. Thus, the aim of this study was to evaluate the effect of blends with different ratios of sorbitol and glycerol, at 2 plasticizer concentrations, on mechanical, viscoelastic, and water vapor barrier properties of films based on gelatin. The films were prepared with 2 g gelatin/100 mL of water and with 25 or 55 g plasticizer/100 g gelatin. The ratio, glycerol to sorbitol, was studied as 0:100, 20:80, 40:60, 60:40, 80:20, and 100:0. The increase of plasticizer concentration from 25 to 55 g plasticizer/100 g gelatin caused an increase of flexibility and reduction of resistance and water vapor barrier as expected. In relation to the effect of the mixture, the increase in the proportion of glycerol caused a reduction of the puncture force, tensile strength, modulus of elasticity, and an increase of the puncture deformation, elongation at break, and water vapor permeability due to the higher plasticizing effect of glycerol. This behavior was explained in terms of molecular weight of the plasticizers, which demonstrated that the studied properties could be considered as functions of the number of molecules of plasticizers in the films.