Physical activation of diatomite-templated carbons and its effect on the adsorption of methylene blue (MB)

Abstract

One- and two-step physical activation methods, using CO2 and H2O as activation agents, were performed to enhance the porosity of diatomite-templated carbons. The morphology, pore parameters, and adsorption capacity of diatomite-templated carbons before and after activation were investigated to evaluate the effects of activation. The results showed deconstruction of the macroporous structure occurred after one-step activation, while two-step activation retained the unique tubular and pillared macroporous structure of diatomite-templated carbon, indicating a highly promising activation method. The new-appearing pores after two-step activation were mainly micropores, which formed on the walls of carbon tubes and pillars. Pore parameters, such as the specific surface area and pore volume, as well as the micropore volume, showed a great increase after two-step activation and were 2–3 times larger than those of the original carbon. CO2 was more effective in enhancing the porosity than H2O during two-step activation, and the obtained carbon products had a higher specific surface area and pore volume. Moreover, the carbon products after two-step activation possessed a larger adsorption capacity of methylene blue than the original carbon; the maximum Langmuir adsorption capacity of MB on the CO2-activated carbon was 505.1mg/g.