Abstract
A novel thin-film lithium-ion battery (LIB) which can be charged by the light irradiation was fabricated by molecular precursor method. The unprecedented, translucent thin-film LIB, fabricated on a fluorine-doped tin oxide pre-coated glass substrate, was attained by using the active materials, titania for anode and LiCoO2 for cathode, respectively. The averaged potential at 2.04[Formula: see text]V was observed by applying a constant current of 0.2[Formula: see text]mA. Then, that at 1.82[Formula: see text]V was detected after 60[Formula: see text]s during the sequential self-discharge process. The charging voltage of the assembled battery was 1.38[Formula: see text]V with irradiation of 1-sun, the self-discharge voltage was 1.37[Formula: see text]V. Based on the calibration curve of the charging voltages over constant currents ranging from 0–1.0[Formula: see text]mA, the detected value can be theoretically reduced to the charging operation by applying a constant current of approximately 60[Formula: see text][Formula: see text]A. The charge and discharge of this device was stable voltage at least 30 cycles. The two-in-one device can simultaneously generate and store electricity from solar light, the renewable energy source, and may be applied in smart windows for distributed power system according to on-site demand.
Highlights
Distributed power generation using renewable energy sources, such as solar light, can efficiently supply electricity according to on-site demand
Regarding the chemical fabrication of two-in-one lithium-ion battery (LIB), we are interested in the photovoltaic nature of LIBs including transparent thin films of titania on their anodes because we previously fabricated both a transparent photocatalytic titania thin film and the abovementioned LIB using the molecular precursor method (MPM), which was mainly developed in our prior study.[6]
The precursor films of the titania and LiCoO2 thin films were formed using a spin-coating method with the commercially available, newly prepared precursor solution at ambient temperature to fabricate the active materials on the fluorine-doped tin oxide (FTO) pre-coated glass substrate
Summary
Distributed power generation using renewable energy sources, such as solar light, can efficiently supply electricity according to on-site demand. A wet process known as the molecular precursor method (MPM) was used to fabricate the active material thin-films with thicknesses of 100 nm on the substrates.[1] In the charge/discharge cyclic test of the LIB assembled with these electrodes, the synchronous electrochromic reactions of the LTO were clearly observed during repeated operation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.