Abstract
We describe the layer-by-layer (LBL) fabrication of multilayer films and photovoltaic cells using poly(phenylene ethynylene)-based anionic conjugated polyelectrolytes as electron donors and water-soluble cationic fullerene C60 derivatives as acceptors. LBL film deposition was found to be linearly related to the number of bilayers as monitored by UV-vis absorption. Atomic force microscopy (AFM) and scanning electron microscopy (SEM) of the multilayer films revealed an aggregated but relatively uniform morphology devoid of any long-range phase separation. The maximum incident monochromatic photon to current conversion efficiency (IPCE) of the photovoltaic cells was 5.5%, the highest efficiency reported to date for cells fabricated by using the LBL fabrication technique, and since the thin film cells do not provide complete absorption of the incident light, the current generation per photon absorbed may be as much as 10%. The cells exhibited open circuit voltages of 200-250 mV with highest measured short circuit currents up to 0.5 mA/cm2 and fill factors around 30%. The power conversion efficiencies measured at AM 1.5 solar conditions (100 mW/cm2) varied between 0.01 and 0.04%, and similar to the IPCE results, the efficiency is a function of the thickness of the PV active layer.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.