Photoresponse of Ti3C2Tx MXene promotes its adsorptive-reductive removal of Cr(VI) from water

Abstract

MXenes, such as Ti3C2Tx, demonstrate tremendous potential as heavy metal adsorbents due to their abundant reaction sites, high hydrophilicity, controllable interlayer spacing, and inherent reduction ability. However, their structural dependent pollutant removal performances and the related mechanisms are far less studied. Therefore, the removing abilities of Cr(VI) from water on Ti3C2Tx MXenes with different structures (multilayer (ML-) and delaminated (DL-) Ti3C2Tx) synthesized via several etching techniques were evaluated. Focusing on the most effective ML- and DL-Ti3C2Tx obtained by acid/fluoride salt etching, the impacts of structural variations on the Cr(VI) removal performances were explored. Both ML- and DL-Ti3C2Tx demonstrate outstanding Cr(VI) adsorption and reduction capabilities, achieving equilibrium within 500 min with capacities of 92.7 and 205 mg/g, respectively. The differences in removal mechanisms stemed from the varying adsorption and reduction capacities of two MXenes. ML-Ti3C2Tx, with lower surface area and porosity, had low adsorption capacity but superior reduction ability, efficiently converting most Cr(VI) to Cr(III) (66.8%). Conversely, DL-Ti3C2Tx exhibited better removal efficiency but a lower capacity for reduction (45.7%). Notably, although the partial reduction of DL-Ti3C2Tx to TiO2 results in its limited chemical reduction capacity, Ti3C2Tx might serve as a co-catalyst for TiO2, boosting the photoresponsiveness of DL-Ti3C2Tx or TiO2 through Ti3C2Tx/TiO2 heterojunctions, thereby facilitating photocatalysis to realize the reduction of Cr(VI). Both Ti3C2Tx exhibited both excellent Cr(VI) removal capacity and detoxification capacity, demonstrating their high potential in treating heavy metal pollutants in wastewater.