Photoluminescence enhancement from hot nitrogen-ion implanted Si quantum dots embedded within SiO2 layer

Abstract

Using the novel process of hot N+-ion implantation at 800 °C into Si quantum dots (Si-QDs) with approximately 3.2 nm fabricated by hot Si+-ion implantation into an SiO2 layer and post-Ar annealing, we experimentally demonstrated that the photoluminescence intensity (IPL) of the Si-QDs increased with increasing N+-ion dose (DN+). Post-N2 high-temperature annealing without hot N+-ion implantation, as a reference process, also increased the IPL of Si-QDs, because N atoms trapped within Si-QDs, which was evaluated by secondary ion mass spectrometry, terminate the dangling bonds within Si-QDs and at the Si/SiO2 interface. Additionally, the IPL of Si-QDs showed the maximum value at the optimal DN+ of 5 × 1015 cm−2, which was 1.4-fold higher than that observed without hot N+-ion implantation. With a short post-annealing time (<60 min), the increase in IPL owing to N+-ion implantation was considerably larger than that caused by N2 annealing, which is likely due to the efficiency of the termination of the dangling bonds of the Si-QDs by the N+-ions. This is an advantage of the hot N+-ion implantation technique. Forming gas annealing after furnace annealing also induced a larger IPL than that observed before forming gas annealing. However, the maximum IPL observed after forming gas annealing was completely independent of the conditions of furnace annealing and DN+. This suggests that the perfect termination of the dangling bonds of the Si-QDs may be realized via forming gas annealing after furnace annealing.