Abstract
The magnitudes and positions of the principal stress indices at a series of isolated oblique holes in thick, wide plates subjected to uniaxial tension have been determined using the photoelastic frozen-stress technique. The model series covered nominal plate thickness to hole diameter ratios of 1.33, 2.0, and 3.0, hole obliquity angles of 0, 15, 30, 45, and 60 degrees, and applied load directions of 0, 30, 60, and 90 degrees relative to the major axis of the surface ellipse. The results are discussed in detail and compared with other independent values available in the literature.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: The Journal of Strain Analysis for Engineering Design
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
