Abstract
Conformer-specific, vibrationally resolved electronic spectroscopy of benzylallene (4-phenyl-1,2-butadiene) is presented along with a detailed analysis of the products formed via its ultraviolet photoexcitation. Benzylallene is the minor product of the recombination of benzyl and propargyl radicals. The mass-selective resonant two-photon ionization spectrum of benzylallene was recorded under jet-cooled conditions, with its S(0)-S(1) origin at 37,483 cm(-1). UV-UV holeburning spectroscopy was used to show that only one conformer was present in the expansion. Rotational band contour analysis provided rotational constants and transition dipole moment direction consistent with a conformation in which the allene side chain is in the anti position, pointing away from the phenyl ring. The photochemistry of benzylallene was studied in a pump-probe geometry in which photoexcitation occurred by counter-propagating the expansion with a photoexcitation laser. The laser was timed to interact with the gas pulse in a short tube that extended the collisional region of the expansion. The products were cooled during expansion of the gas mixture into vacuum, before being interrogated using mass-selective resonant two-photon ionization. The UV-vis spectra of the photochemical products were compared to literature spectra for identification. Several wavelengths were chosen for photoexcitation, ranging from the S(0)-S(1) origin transition (266.79 nm) to 193 nm. Comparison of the product spectral intensities as a function of photoexcitation wavelength provides information on the wavelength dependence of the product yields. Photoexcitation at 266.79 nm yielded five products (benzyl radical, benzylallenyl radical, 1-phenyl-1,3-butadiene, 1,2-dihydronaphthalene, and naphthalene), with naphthalene and benzylallenyl radicals dominant. At 193 nm, the benzylallenyl radical signal was greatly reduced in intensity, while three additional C(10)H(8) isomeric products were observed. An extensive set of calculations of key stationary points on the ground state C(10)H(10) and C(10)H(9) potential energy surfaces were carried out at the DFT B3LYP/6-311G(d,p) level of theory. Mechanisms for formation of the observed products are proposed based on these potential energy surfaces, constrained by the results of cursory studies of the photochemistry of 1-phenyl-1,3-butadiene and 4-phenyl-1-butyne. A role for tunneling on the excited state surface in the formation of naphthalene is suggested by studies of partially deuterated benzylallene, which blocked naphthalene formation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have