Phosphorus reduction in filters for on-site wastewater treatment

Abstract

Discharges of phosphorus (P) from on-site wastewater treatment systems generally contribute to eutrophication problems in Swedish freshwaters and, ultimately, in the Baltic Sea. Such concerns have led to a growing interest in improving P removal in treatment facilities. This study investigated the reduction of P in 12 full-scale on-site treatment systems featuring sand filters and alkaline P-filters by sampling and analysing filter influents and effluents. The flow-proportional samples collected were analysed for total and dissolved P, BOD7, total and dissolved organic carbon (TOC and DOC), and pH. Seven of the eight investigated sand filters did not provide satisfactory total P reduction; the likely explanations are filter clogging and wastewater dilution by extraneous water. In addition, effluents from four of the eight sand filters had total P concentrations higher than 3 mg L−1, which is the Swedish effluent limit recommended for common receiving waters, indicating that a subsequent polishing step would be needed. Six of the nine investigated P-filters reduced P adequately, with total P concentrations in the effluent ranging between 0.1 and 1.9 mg L−1. The three underperforming P-filters had effluent pH values below 9; filter age, clogging, and hydraulic overload were identified as probable reasons for their poor performance. A statistically significant correlation was found between total-P reduction and filtrate pH, but no significant correlation was detected between organic load in the influent and P reduction by the P-filters. The P-filter media replacement frequency could not be established, but filtrate pH appeared to be a good estimator.