Abstract

Four phenylurea herbicides (PUHs) were assessed for degradation and transformation into N-nitrosodimethylamine (NDMA) under three oxidation conditions (chlorine (Cl2), chlorine dioxide (ClO2), and ozone (O3)) from an aqueous solution. Removal ratios correlated with the numbers of halogen elements contained in PUHs (isoproturon (0)>chlorotoluron (1 Cl)>diuron (2 Cl)>fluometuron (3F)), and the degradation efficiencies of oxidants from fastest to slowest were: O3, ClO2, and Cl2. NDMA can be generated directly from the ozonation of PUHs. Further, compared with chloramination alone, ozonation prominently promoted NDMA formation potential (NDMA-FP) during post-chloramination, and NDMA-FPs increased approximately 23-68 times than those during ozonation only at 2.5mg/L O3 over 10min; molar yields of NDMA from highest to lowest were 11.1% (isoproturon), 1.17% (chlorotoluron), 1.0% (diuron), and 0.73% (fluometuron). The PUH degradation kinetics data during ozonation agreed with the pseudo-first-order model. The rate constant kobs were 0.31×10-3-19.8×10-3s-1. The kobs and removal ratios of PUHs during ozonation partially scaled with the mass, LogKow, and Henry's constants of PUHs. Comparisons of measured NDMA-FPs with calculated NDMA-FPs from residual PUH after oxidation showed that the intermediates produced during ozonation facilitated NDMA-FPs; this contribution was also observed for chlorotoluron and isoproturon during ClO2 oxidation. Examination of reaction mechanisms revealed that tertiary amine ozonation, N-dealkylation, hydroxylation, the cleavage of N-C bonds, ammonification, and nitrification occurred during the ozonation of PUHs, and the dimethylamine (DMA) functional groups could be decomposed directly and transformed into NDMA via the formation of the intermediate unsymmetrical dimethylhydrazine. NDMA is also formed from the reaction between DMA and phenylamino-compounds. Clarifying primary degradation products of PUHs and transformation pathways of NDMA during oxidation processes is useful to optimize treatment processes for water supplies.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.