Abstract
A challenge in phenology studies is understanding what constitutes phenological change amidst background variation. The majority of phenological studies have focused on extracting critical points in the seasonal growth cycle, without exploiting the full temporal detail. The high degree of phenological variability between years demonstrates the necessity of distinguishing long-term phenological change from temporal variability. Here, we demonstrate the phenological change detection ability of a method for detecting change within time series. BFAST, Breaks For Additive Seasonal and Trend, integrates the decomposition of time series into trend, seasonal, and remainder components with methods for detecting change. We tested BFAST by simulating 16-day NDVI time series with varying amounts of seasonal amplitude and noise, containing abrupt disturbances (e.g. fires) and long-term phenological changes. This revealed that the method is able to detect the timing of phenological changes within time series while accounting for abrupt disturbances and noise. Results showed that the phenological change detection is influenced by the signal-to-noise ratio of the time series. Between different land cover types the seasonal amplitude varies and determines the signal-to-noise ratio, and as such the capacity to differentiate phenological changes from noise. Application of the method on 16-day NDVI MODIS images from 2000 until 2009 for a forested study area in south eastern Australia confirmed these results. It was shown that a minimum seasonal amplitude of 0.1 NDVI is required to detect phenological change within cleaned MODIS NDVI time series using the quality flags. BFAST identifies phenological change independent of phenological metrics by exploiting the full time series. The method is globally applicable since it analyzes each pixel individually without the setting of thresholds to detect change within a time series. Long-term phenological changes can be detected within NDVI time series of a large range of land cover types (e.g. grassland, woodlands and deciduous forests) having a seasonal amplitude larger than the noise level. The method can be applied to any time series data and it is not necessarily limited to NDVI.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.