Abstract
A variant of tape casting based on the phase inversion phenomenon was adopted for fabrication of porous ceramic wafer. A slurry was prepared by dispersing alumina powder in an N-methyl-2-pyrrolidone (NMP) solution of the polymers polyethersulfone (PES) and polyvinylpyrrolidone (PVP). The slurry was cast using a doctor blade, and immersed in water to solidify the polymer solution via phase inversion. The green tape was dried and sintered at 1500 ◦C. The as-prepared ceramic wafer was characterized using synchrotron-radiation computed tomography (SR-CT). It was revealed that the ceramic wafer contained typical finger-like macrovoids, and the porosity resulting from these macrovoids was ∼30%. The overall porosity of the wafer was 59%, as derived from the density data measured by Archimedes method in mercury. It is concluded that the phase inversion tape casting is a simple and effective method for preparation of porous ceramics.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.