Phase transformations of a spray-dried iron catalyst for slurry Fischer–Tropsch synthesis during activation and reaction

Abstract

The consecutive phase transformations of a precipitated spray-dried iron-based catalyst for slurry Fischer–Tropsch synthesis (FTS) during activation and reaction process were investigated using Mössbauer effect spectroscopy (MES). It was found that the fresh iron catalyst activation in situ using syngas resulted in the formation of a mixture of iron carbides and superparamagnetic (spm) phases. The relatively small size of fresh iron crystallites was an important factor in the formation of ε′-Fe 2.2C. During the reduction process, Fe 3+ (spm) phase was easier to be reduced than α-Fe 2O 3 phase. Fe 3O 4 was not an active phase for FTS. The transformation of α-Fe 2O 3 into Fe 3O 4 before carbides formation was necessary to obtain FTS activity of the iron catalyst. There was a correlation between the content of CH 4 in tail gas and the amount of iron carbides during activation. It was found that carbonization was the dominating phase transformation when the FTS reaction temperature increased from 250 °C to 270 °C. However, the oxidization was more remarkably at higher FTS reaction temperature. χ-Fe 5C 2 was the main iron phase at lower reaction temperature. The changes in the bulk compositions resulted in the variation in catalyst activity during FTS. The results of this study showed that the active phase for FTS was a mixture of carbides and corresponding amounts of superparamagnetic phase.