Abstract
The aim of this study was to investigate phase formation under steam oxidation conditions and steam oxidation behaviours of two solid-solution-strengthened alloys—HAYNES® 230® and 617 alloy—two gamma-prime (γ′)-strengthened alloys—263 and HAYNES® 282®—and finally three austenitic steels rich in Cr—309S, 310S and HR3C. The samples were tested under 1 bar pressure in 100 % water–steam–water system at 800 °C for 1000 h. It was found that Ni-based solid-solution-strengthened alloys, HAYNES® 230® and 617 alloy, developed mainly Cr2O3 and MnCr2O4 phases on their surfaces, whereas the γ′-strengthened alloys, 263 and HAYNES® 282®, formed Cr2O3, TiO2 and MnTiO3 phases, indicating slightly higher corrosion degradation rate. The austenitic steels exposed for 1000 h formed Cr2O3, Fe3O4 and MnCr2O4 with traces of Fe,Mn(SiO)4. Some sites on the austenitic steel surfaces were enriched with Fe3O4 with little amount of Cr. During the test, no spallation of the external oxide scale was observed. The kinetic data showed that only the 263 alloy oxidized according to parabolic behaviour, whereas the other alloys deviated from the parabolic rate law, with time exponents of 0.4–0.6 or 0.3. Finally, cross-sectioned investigations of the exposed samples revealed that Ni-based alloys underwent extended internal oxidation, with the highest extent in HAYNES® 282® reaching 25 μm and the lowest in HAYNES® 230® alloy reaching 7 μm. The austenitic steels showed no internal oxidation phenomena.
Highlights
According to the International Energy Agency Energy Statistics, electricity and heat production accounts for 41 % of the total CO2 emissions worldwide
The lowest weight gain under steam oxidation conditions has been observed in solid-solution-strengthened HAYNESÒ 230Ò alloy and the highest weight gain was observed in HAYNESÒ 282Ò
The weight gain of Ni-based samples exposed to steam oxidation were very similar ranging from 0.37 mg/cm2 (HAYNESÒ 230Ò) to 0.80 mg/cm2 (HAYNESÒ 282Ò), respectively
Summary
According to the International Energy Agency Energy Statistics, electricity and heat production accounts for 41 % of the total CO2 emissions worldwide. The energy sector is contributing to these goals by increasing the power generation efficiency; it is well known that the efficiency of electrical output is a function of temperature and pressure of the steam entering the steam turbine [3,4,5]. Hot sections of currently operating power plants (super heaters and re-heaters) use low or medium alloyed steels. Such steels possess low corrosion resistance at a temperature range of 700–760 °C during which thick, non-protective scales with flaky, brittle structures susceptible to continuous scale spallation are formed, resulting in high metal loss and wall thinning and leading to the inability to withstand high steam pressures [7, 8]
Sign-in/Register to view highlights & summary Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
