Phase hold-up and critical fluidization velocity in a three-phase inverse fluidized bed

Abstract

We studied the hydrodynamic characteristics of a three-phase inverse fluidized bed made of a transpar- ent acrylic column of 0.115 m inner diameter and 2 m heights. Air, water and polyethylene particles were used as the gas, liquid and solid phase, respectively. We used both hydrophobic low density polyethylene (LDPE) and hydrophilic LDPE as solid phase, and distilled water as liquid phase, and filtered air as gas phase. The LDPE was chemically treated by chlorosulfonic acid to change the surface property from hydrophobic to hydrophilic. We tried to solely investigate the effect of the surface hydrophilicity of polymeric particles on the phase holdup and the critical fluidization velocity of three-phase inverse fluidization. Thus, we measured the static pressure and eventually observed critical fluidization velocity. Critical fluidization velocity became smaller in case of using MDPE hydrophobic particles than LDPE hy- drophilic particles. This was thought to be due to the retardation of rising bubbles near hydrophobic particles and, sub- sequently, the increase of gas hold-up.