Abstract
SUMMARYThe accurate magnetic properties of electrical steel sheets are important for the development of high‐efficiency electromagnetic devices. In particular, the H‐coil method is a useful technique for accurately measuring magnetic field strength in a single sheet tester. Therefore, we developed a tester for magnetic field properties using the H‐coil method, referred to as the stress load type single sheet tester (S‐SST), and a problem was found in iron loss measurement at a high flux density of 1.6 T or more. In this paper, it is shown that the cause of this problem is the phase difference between the induced voltage in the H‐coil and the B‐coil. Because the phase difference makes the B–H loop slightly twisted near the tip point, the iron losses are evaluated low. Thus, we propose a method of determining the phase correction values. These values are measured in the absence of a specimen in the S‐SST measurement system, and the phase correction method for induced voltage in a coil is investigated. Finally, ideal results for the correction of iron loss in nonoriented electrical steel sheets are shown. The proposed method is effective for the calibration of a single sheet tester using the H‐coil method.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
