Phase change characteristics and their effect on the performance of hydrogen recirculation ejectors for PEMFC systems

Abstract

The working fluid of the hydrogen recirculation ejector in proton exchange membrane fuel cell (PEMFC) systems is humid hydrogen containing water vapour. However, previous studies on the hydrogen recirculation ejector using computational fluid dynamics (CFD) were based on the single-phase flow model without considering the phase change of water vapour. In this study, the characteristics of the phase change and its effect on the ejector performance are analysed according to a two-phase CFD model. The model is established based on a non-equilibrium condensation phase change. The results show that the average deviation of the entrainment ratio predicted by a single-phase flow model is 25.8% compared with experiments involving a hydrogen recirculation ejector, which is higher than the 15.1% predicted by the two-phase flow model. It can be determined that droplet nucleation occurs at the junction of the primary and secondary flow, with the maximum nucleation rate reaching 4.0 × 1020 m−3s−1 at a primary flow pressure of 5.0 bar. The higher temperature, lower velocity, and higher pressure of the gas phase can be found in the mixing region due to condensation, resulting in a lower entrainment performance. The nucleation rate, droplet number, and liquid mass fraction increase remarkably with an increasing primary flow pressure. This study provides a meaningful reference for understanding phase change characteristics and two-phase flow behaviour in hydrogen recirculation ejectors for PEMFC systems.