Phantomuntersuchungen an einem hochauflösenden CT zur Ex-vivo-Darstellung von degradierbaren Magnesiumimplantaten und simulierten periimplantären Knochenschichten in Kaninchentibiae

Abstract

Evaluation of the suitability of the high-resolution CT XtremeCT for ex vivo imaging of degradable magnesium implants with simulated peri-implant bone formation in rabbit tibiae and development of a method for calibrating the mass concentration of a magnesium alloy in an implant volume. Using specially designed phantoms, degradable magnesium implants of the alloys LAE442, ZEK100, AX30 and MgCa 0.8 %, without coating and with peri-implant bone formation simulated by a coating, as well as rabbit tibiae were scanned. CT numbers and the contrast-to-noise-ratio (CNR) of the studied materials were determined. The visual distinction between implant and coating was evaluated. To calibrate the implant density, exemplary LAE442 pins with different mass concentrations were scanned using a specially constructed phantom. Subsequently, CT numbers corresponding to the appropriate mass concentration were determined. The implants, coating and substantia corticalis showed a similar density. Visual distinction between coating and implant was strongly dependent on the respective magnesium alloy and chosen scan parameter. A CNR of at least 0.2 was required for a distinction between implant and coating. For the mass concentration, a high CT number linearity (R2=0.99) throughout the measuring range (1811-1273 mg/cm3 LAE442) was found. As expected, the XtremeCT is primarily suitable for the imaging of bone tissue and implants. Good visual distinction of peri-implant bone formation on magnesium implants in an ex vivo phantom model ranges from possible to difficult depending on the bone density and alloy composition.