PFAS and DOM removal using an organic scavenger and PFAS-specific resin: Trade-off between regeneration and faster kinetics

Abstract

Treatment technologies such as ion exchange (IX) process exhibit promising potentials for the removal of toxic per- and poly-fluoroalkyl substances (PFAS) from natural waters. In recent years, industries have started manufacturing PFAS-specific resins which are typically operated in a single use-and-dispose mode until exhaustion. However, this increases the resin demand and the consequent operational cost and environmental burden of the IX process. In this study, the performance of a PFAS-specific resin (A592) was compared with that of a regenerative organic scavenger resin (A860) which is traditionally employed for dissolved organic matter (DOM) and micorpollutant removal. Comparative studies were performed to examine the removal of multiple long- and short-chain carboxylic, sulfonic, precursor and emerging PFAS (including GenX) from synthetic and natural waters. The A592 resin exhibited faster uptake kinetics for PFAS while simultaneously removing 10–15% of DOM. The A860 resin removed ~60–70% of DOM; however, it required approximately 3-fold higher contact times for achieving the same degree of PFAS removal when compared to the PFAS-specific resin. The resin breakthrough (Ctreated (PFAS) > 70 ng/L) was observed around 125,000 ± 5000 bed volumes (BVs) for the PFAS-specific resin (via multiple loading tests), while it ranged between 15,000–27,000 BVs for the organic scavenger. Yet, a mass balance on PFAS and DOM removal indicated ~90–98% site saturation (in milli-equivalents (meqs)) on both IX resins before exhaustion. More importantly, the regenerated organic scavenger resin (A860) exhibited PFAS and DOM removal capabilities for longer operational BVs when compared to A592 operated in a single-use-mode in natural waters.