Abstract

The Gies gold-silver telluride deposit, Judith Mountains, Montana, occurs in steeply dipping quartz veins near the contact of Late Cretaceous to Paleocene alkaline porphyritic intrusions (quartz monzonite and syenite stocks, and tinguaite dikes), and sedimentary rocks (shale, sandstone, conglomerate, limestone, and dolomite) of Middle Cambrian to late Paleocene age. Trace element geochemistry suggests that these intrusions were possibly derived from the shallowly dipping subducting Farallon plate lithosphere or the overlying asthenospheric mantle.Vein-related alteration is variable and does not extend more than 100 m away from veins. Potassic alteration and silicification are most closely associated with telluride mineralization. The vein mineralogy is complex and consists of at least 36 minerals including two unknown possibly new minerals and six tellurides. Four stages of vein mineralization are recognized in the Gies deposit, the dominant mineral assemblages are (I) quartz-pyrite-roscoelite-carbonates, (II) quartz-pyrite-base metal sulfides-carbonates-minor tellurides-roscoelite, (III) quartz-tellurides-pyrite-roscoelite-base metal sulfides-sulfosalts, and (IV) sulfides-sulfosalts-native gold. Fluid inclusion studies of quartz from stages I, II, and III yield homogenization temperatures of 270 degrees to 319 degrees C (mean = 293 degrees + or - 10 degrees C), 222 degrees to 282 degrees C (mean = 256 degrees + or - 9 degrees C), and 195 degrees to 250 degrees C (mean = 220 degrees + or - 13 degrees C), respectively. Assuming hydrostatic pressure, a 5 degrees C correction due to pressure yields mean trapping temperatures of approximately 300 degrees , 260 degrees , and 225 degrees C, respectively, for stages I, II, and III. Salinities of primary fluid inclusions in all three quartz stages range from 5.7 to 8.0 wt percent NaCl equiv.Isotopic studies show that delta 34 S values between -1.0 to 3.1 per mil for vein sulfides are most consistent with a magmatic origin. Oxygen isotope values of quartz in stages I, II, and III range from 13.1 to 18.1 per mil, whereas values for feldspar in unaltered alkaline intrusions range from 7.1 to 9.8 per mil, feldspar in altered alkaline intrusions from 7.3 to 9.8 per mil, and a single sample of stage III kaolinite is 7.9 per mil. Values of delta 18 O water computed from quartz and fluid inclusion trapping temperatures for stage I, II, and III fluids are 5.9 to 9.4 per mil, 6.4 to 8.7 per mil, and 3.6 to 6.2 per mil, respectively. A delta 18 O value of 3.3 per mil for fluid in equilibrium with stage III kaolinite agrees well with values derived from fluids in equilibrium with stage III quartz. Hydrogen isotope values of stage II roscoelite, stage III kaolinite, and fluid inclusions in stage I, II, and III quartz range from -115 to -78 per mil, whereas fluids in equilibrium with these minerals range from -115 to -88 per mil.Oxygen and hydrogen isotope evidence suggests that gold telluride mineralization precipitated by conductive cooling in response to increased mixing of evolved meteoric water with magmatic fluids. Concomitant with a decrease in temperature from stage I through stage IV are decreases in pH, f (sub S 2 ) , and f (sub O 2 ) and increases in f (sub Te 2 ) and vanadium content of the ore-fluid. Geologic and mass balance calculations are consistent with a low water/rock ratio (<0.1) and indicate that magmatic fluids and many of the ore-forming components (e.g., Au, Ag, Te, V, S) have possibly been derived from a buried intrusion (e.g., tinguaite or carbonatite) at approximately 59 Ma.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call