Abstract
A privacy-preserving sensor for person localization has been developed. In theory, the sensor can be constructed with a line sensor and cylindrical lens because only a one-dimensional brightness distribution is needed. However, a line sensor is expensive. In contrast, CMOS area sensors are low cost and are increasing in sensitivity according to recent rapid advancement in the technology. Therefore, we covered the CMOS area sensor physically so that it behaved as a line sensor, we substituted CMOS sensors for the line sensors in practice. The proposed sensor obtains a one-dimensional horizontal brightness distribution that is approximately equal to the integration value of each vertical pixel line of the two-dimensional image. It is impossible to restore the two-dimensional detail texture image from one-dimensional brightness distribution, although it obtains enough information to detect a person’s position and movement status. Thus, the privacy is protected. Moreover, the appearance of the proposed sensor is very different from the conventional video camera, so the psychological resistance of having a picture taken is reduced. In this work, we made the privacy preserving sensor practically, and verified whether a person’s state was able to be detected. The simulation results show that the proposed sensor can detect a present person’s state responsively without violating privacy.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.