Permeability-Enhancing Technology through Liquid CO2 Fracturing and Its Application

Abstract

Liquid carbon dioxide (CO2) phase change fracturing (LCPCF) is an innovative technique to improve the efficiency of gas drainage from low-permeability coal seams of high gas content. However, fracture sprouting, extension and displacement changes of coal under LCPCF need further study, and corresponding field tests are also lacking. Therefore, a mechanical model based on the thermodynamic theory of CO2 phase change is developed in this paper. Then, the pressure change characteristics, crack propagation and displacement change of coal subjected to LCPCF were analyzed through numerical simulation. In addition, the permeability-enhancing effect of the field LCPCF test was analyzed. The results obtained from the numerical simulation show that during the LCPCF process, the crack-generation process changes with pressure as follows: microfracture–numerous microfractures–major macrofracture–macrofractures. During the development of fractures, the stress is incompletely symmetrically distributed in coal centered on the fracturing borehole. The failure occurs stochastically in the coal in the vicinity of the fracturing borehole at first, and then it gradually propagates to the inner seam of coal as the gas pressure increases. The following result can be obtained from field experiments: the permeability coefficient of coal seams after increasing the permeability through LCPCF is 2.60~3.97 times that of coal seams without presplitting. The average concentration of gas extracted in coal seams within the zone having undergone an increase in permeability through liquid CO2 fracturing is 2.14 times greater than that within the zone without presplitting. The average pure amount of gas extracted within the zone having undergone an increase in permeability through LCPCF is 3.78 times greater than that within the zone without presplitting. By comparing coal seams before and after fracturing in the field test, it can be seen that the LCPCF presents a favorable effect in increasing the permeability of low-permeability coal seams. This provides an effective approach for increasing the permeability of coal seams in coal mines with similar geological conditions.