Abstract
Temporary supply of CO during propyne hydrogenation over a copper-based catalyst derived from a Cu–Al hydrotalcite permanently increased the alkene selectivity from 60% to 92% at 100% alkyne conversion (473 K). The superior performance of the CO-modified copper catalyst (higher alkene selectivity and resistance against deactivation by fouling) was further confirmed at lower temperature (373 K). Our catalytic results suggested that carbon monoxide in the presence of propyne and hydrogen irreversibly restructures the catalyst surface leading to a smaller copper ensemble that minimizes C–C coupling. Consequently, the enhanced alkene production in the CO-modified catalyst was coupled to a decreased oligomer production and very little propane production. The pretreatment mixture, feed CO concentration, and type of alkyne are important aspects to attain a selective copper catalyst. The CO effect in alkyne hydrogenation over copper radically differs from that over palladium or nickel. On the latter two metals, the increased alkene selectivity in the presence of CO is mostly due to a reduction in the over-hydrogenation channel. In addition, the effect is fully reversible, that is, it vanishes on removing CO from the feed. The permanent modification of the copper ensemble by CO might be advantageous for (chemo) selective hydrogenations of high acetylenic substrates.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.