Abstract
According to the goal of the XFP MSA group (10 gigabit small form factor pluggable, XFP, multi source agreement, MSA) of creating a specification for a hot pluggable module converting serial electrical signals to external serial optical or electrical signals, the development of a 10 gigabit connector system with a ball contact principle between a flex print line and a standard printed wiring board has been carried out. The mechanical dimensions and the electrical parameters is determined. Based on this special ball contacting system the following report discusses the mechanical parameters of the contact pressure in the constriction area as well as the active contact area dimensions and the resulting contact resistance. The reflection factor is calculated for the utilization and application of high speed data transfer up to 10 Gbps. The ball contact principle guarantees extremely low mechanical dimensions and is excellently suitable for signal transfers of extremely high data rates; only lowest electrical imperfections is generated. The calculations of mechanical and electrical characteristics use the elastic-plastic material properties of galvanic metal plating and treat with the base materials like copper (Cu) and Gold (Au), as well as the glass fibre-reinforced epoxy material for printed wiring boards. The layer deformation is verified by laboratory testing and measurements.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.