Abstract
The success of direct-drive-ignition target designs depends on two issues: the ability to maintain the main fuel adiabat at a low level and the control of the nonuniformity growth during the implosion. A series of experiments was performed on the OMEGA Laser System [T. R. Boehly, D. L. Brown, R. S. Craxton et al., Opt. Commun. 133, 495 (1997)] to study the physics of low-adiabat, high-compression cryogenic fuel assembly. Modeling these experiments requires an accurate account for all sources of shell heating, including shock heating and suprathermal electron preheat. To increase calculation accuracy, a nonlocal heat-transport model was implemented in the 1D hydrocode. High-areal-density cryogenic fuel assembly with ρR>200mg∕cm2 [T. C. Sangster, V. N. Goncharov, P. B. Radha et al., “High-areal-density fuel assembly in direct-drive cryogenic implosions,” Phys. Rev. Lett. (submitted)] has been achieved on OMEGA in designs where the shock timing was optimized using the nonlocal treatment of the heat conduction and the suprathermal-electron preheat generated by the two-plasmon-decay instability was mitigated.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
