Performance evolution and mechanism of asphalt crack sealant under UV aging: A continuity study

Abstract

Asphalt crack repair materials, known as crack sealants, are directly exposed to ultraviolet (UV) radiation in asphalt pavements. This exposure causes the gradual aging and deterioration of both their surface and internal properties. To study this phenomenon, the sealant was subjected to UV irradiation for a range of 0–385 hours, with the basic properties of the aged sealant tested every 55 hours. Several techniques were employed to investigate the changes in the internal chemical composition of the sealant, including Fluorescence microscopy (FM), gel permeation chromatography (GPC) and Fourier transform infrared spectroscopy (FT-IR). The results revealed that the UV aging of the sealant mainly occurs in the thinner surface layer, which becomes progressively lighter in color. Notably, obvious surface cracks form after aging process. The cone penetration and softening point of the sealant exhibit an exponential or logarithmic change corresponding to the aging time. The most pronounced changes occur during the early stages of UV aging, with the properties tending to stabilize after approximately 220 h of aging. In addition, the FM images showed that the dispersed polymer particles within the sealant gradually transform into a continuous network structure after aging over time. The GPC spectrum of the aged sealant shifts to the left, indicating an increase in molecular weight, particularly in the polymer modifier. This is consistent with the transformation observed in the FT-IR analysis, which demonstrates that UV irradiation leads to the breaking and recombination of polymer chemical bonds in the sealant. The FT-IR analysis reveals the conversion of monosubstituted benzene to polysubstituted benzene in the polymer modifier, which also correlates with the formation of the network structure observed in the FM images and the increase in molecular weight detected in the GPC spectrum of the polymer modifier.