Abstract

ABSTRACTMost studies conducted nowadays to boost electrode performance in microbial fuel cell (MFC) have focused on carbonaceous materials. The titanium suboxides (Ti4O7, TS) are able to provide a new alternative for achieving better performance in MFC and have been tested and demonstrated in this study. The Ti4O7 electrode with high electrochemical activity was modified by graphene/polyaniline by the constant potential method. Electrogenic microorganisms were more conducive to adhere to the anode electrode due to the presence of graphene/polyaniline. The MFC reactor with polyaniline /graphene modified TS (TSGP) anode achieves the highest voltage with 980 mV, and produces a peak power density of 2073 mW/m2, which is 2.9 and 12.7 times of those with the carbon cloth anode, respectively, at the 1000 Ω external resistance. In addition, this study evaluates the effects of anolyte conductivity, pH, and COD on the treatment of oil-containing restaurant wastewater (OCRW) in MFC using TSGP anode. The OCRW amended with 120 mS/cm obtains the lowest internal resistance (160.3 Ω). Increasing the anodic pH, gradually from acidic (pH 5.5) to alkaline conditions (pH 8.0), resulted in a gradual increase in maximum power density to 576.4 mW/m2 and a decrease in internal cell resistance to 203.7 Ω. The MFC at the COD 1500 mg/L could obtain steady-state output voltage during 103 h while removing up to 65.2% of the COD of the OCRW.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.