Performance evaluation of coal dust and wood powder ash as alternates of conventional filler in the asphalt concrete

Abstract

Mineral fillers provide a significant role in the Marshall properties of hot mix asphalt for paving applications. The article's goal is to assess the suitability and effectiveness of two minerals (coal dust and wood powder ash) used as fillers in asphalt concrete. Chemical composition test using X-ray fluorescence indicated a high content of SiO2, Fe2O3, and Al2O3, which encouraged us to select the coal dust and wood powder ash as mineral fillers for further investigation. A total of 90 cylindrical Marshall Specimens, made with different percentages (i.e., 4%-8%) of coal dust, wood powder ash, and conventional stone dust filler were prepared to assess the performance of individual filler within the asphalt concrete mix. And after that, volumetric characteristics such as density, stability-flow test, air void, and voids in mineral aggregates have been analyzed to evaluate the effectiveness of every sample and, afterward, to find out the optimum asphalt content. Finally, the optimum asphalt content for every filler material was ascertained, and subsequently, Marshall properties were checked again to assess the optimum filler content in the mix that satisfy all the standard criteria. The overall Marshall properties for both fillers were within the acceptable limits. Though the optimum asphalt content was higher for coal dust than wood powder ash and stone dust, the wood powder ash showed better durability than coal dust. All mixtures have been found to have better resistance to deformation, fatigue, and moisture-induced damages; however, 4% coal dust and 6% wood powder ash satisfied most of the Marshall criteria than other percentages.