Abstract
Use of variable-pitch rotors was compared against variable-RPM rotors on a 2-kg (20 N) quadcopter in simulation. To generate 5 N of thrust in hover while maintaining a 2:1 maximum thrust-to-weight ratio, the variable-pitch rotor required 29% more power. At low climb rates the variable-RPM rotor requires less power, but near its maximum rate it required more power than the variable-pitch rotor. The maximum climb rate for the variable-pitch rotor was up to 70% greater than that of the variable-RPM rotor. A quadcopter equipped with variable-pitch rotors required more power to operate compared to the aircraft with variable-RPM rotors over its operational airspeed range. The variable-pitch quadcopter required 30% more power at best-endurance speed and had 18% less range than the variable-RPM quadcopter (at maximum-range speed). The 1/rev root drag shear was 42% larger for the variable-RPM rotor, and the 2/rev H- and Y-forces were 37% and 50% larger. The 2/rev thrust vibration was 6.5% smaller for the variable-RPM rotor, and the hub pitching and rolling moments were 11% and 9% smaller, respectively. Unlike the quadcopter equipped with variable-pitch rotors, the quadcopter equipped with variable-RPM rotors experienced a beating phenomenon in the aircraft-level vibratory loads.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.