Abstract
In this paper, the intention has to create a network configuration that is similar for all routing protocols RIP, OSPF, and EIGRP by which we want to analysis the performance of these protocols using Cisco Packet Tracer and OPNET simulator. We use various protocols for forwarding the packets in a network topology. For successful delivery of the packets from the source node to the accurate destination node, the routers maintain a routing table. The amount of network information stored by a router depends on its algorithm. For the performance measure, we will simulate real-time scenarios of the networks using Cisco Packet Tracer and OPNET simulation tools. We will evaluate the performance of EIGRP, OSPF, and RIP based on of network convergence, Ethernet delay, security, and bandwidth requirement, etc. We will observe that the EIGRP routing protocol has the maximum link utilization followed by OSPF, and RIP routing protocols.
Highlights
Introduction to Optimized Network Engineering Tools (OPNET)Simulator” http://users. salleurl.edu/~zaballos/opnet_interna/pdf/OPNET%2 0Simulato r.pdf4
We have presented a comparative analysis of EIGRP, OSPF and RIP
A) Convergence Duration Fig.[15] shows that the convergence time of EIGRP is faster than OSPF and RIP networks
Summary
We enable EIGRP routing protocol for all routers on the network. We enable OSPF routing protocol for all routers on the network. We enable RIP routing protocol for all routers on the network. We choose individual DES statistics to select performance metrics and to measure the behavior of the routing protocol. We set simulation run time to 15 minutes
Sign-in/Register to view highlights & summary Sign-in/Register to access full text options 
Free) 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call
