Abstract
Single stage AC/DC converters based on series-parallel resonant circuit and operating above the resonance frequency provide high input power factor. However, with conventional variable frequency control, zero voltage switching may be lost in some operating conditions. In this paper two control techniques for resonant converter operating above resonance frequency are compared. These control techniques ensure zero voltage switching in all operating points allowing operation at high frequencies. A design procedure is suggested for the selection of resonant circuit parameters. Finally experimental results from a 500 W power factor corrected AC/DC power supply are given to verify the predicted results.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
