Abstract
The paper discusses the simulation, performance and optimum design of single-phase-to-2-phase cycloconvertors driving an induction motor. Bridge and centre-tapped circuits using triacs with double-integral control are considered. Results are presented for 2-pole induction-motor drives which may operate at speeds from 0 to 1500 rev/min. The simulation is shown to model the performance of the drives successfully, and is used to predict an optimum design. An improvement to the control algorithm at bank crossover is presented. The bridge circuit is more efficient than the centre-tapped circuit, but uses more triacs.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.