Abstract
A two-stage light gas gun driven by gaseous detonation was newly constructed, which can make up for the disadvantages of the insufficient driving capability of high-pressure gas and the constraints of gunpowder. The performance of the gas gun was investigated through experiments and a quasi-one-dimensional modeling of it was also developed and described in detail. The model accounts for the friction and heat transfer to the tube wall for gases by adding a source term. An improved model has been established to consider the inertial loads in the piston or projectile and model the friction force with the tube wall. Besides, the effects of pump tube pressure on the performance of the gas gun are also investigated numerically. Simulations of the pressure histories in the pump tube and the piston and projectile velocities were conducted. A good agreement was observed between the computational predictions and experimental results. The results showed that the friction between the piston and wall had only small influence on the piston velocity. The proposed numerical approach is suitable for the development of two-stage light gas guns and tests of the operating conditions.
Highlights
A gasdynamic gun is a kind of test facility in which the test models or projectiles are launched at desired velocities and the aerodynamic properties of the flying models are measured during its flight, or shock and damage of the targets are measured upon the projectile impact [1]
P1 is located in the detonation tube and the others are placed in the pump tube
1, including the projectile velocity from the experimental and computational fluid dynamics listed in Table 1, including the projectile velocity from the experimental and computational fluid (CFD)
Summary
A gasdynamic gun is a kind of test facility in which the test models or projectiles are launched at desired velocities and the aerodynamic properties of the flying models are measured during its flight, or shock and damage of the targets are measured upon the projectile impact [1]. The driving capability of this method is not often sufficient, i.e., the available speed or energy of projectile is often not high enough to meet the experimental requirements within the range of operable pressure. The largest two-stage light gas gun in the world, the Arnold Engineering Development Complex (AEDC) Range-G, is capable of launching a projectile of 10 kg to speeds higher than 4 km/s [10] Many studies of this driving method have been conducted, and relevant theories and numerical methods have been developed [6,11,12,13]. Good agreements are obtained between the experimental and simulation results, and propagating into the driving section, thereby igniting the detonable gas directly This will lead including the piston/projectile velocity and pressure histories.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.