Performance and mechanism analysis of sludge-based biochar loaded with Co and Mn as photothermal catalysts for simultaneous removal of acetone and NO at low temperature.

Abstract

Replacing NH3 in NH3-SCR with VOCs provides a new idea for the simultaneous removal of VOCs and NOx, but the technology still has urgent problems such as high cost of catalyst preparation and unsatisfactory catalytic effect in the low-temperature region. In this study, biochar obtained from sewage sludge calcined at different temperatures was used as a carrier, and different Co and Mn injection ratios were selected. Then, a series of sludge-based biochar (SBC) catalysts were prepared by a one-step hydrothermal synthesis method for the simultaneous removal of acetone and NO in a low-temperature photothermal co-catalytic system with acetone replacing NH3. The characterization results show that heat is the main driving force of the reaction system, and the abundance of Co and Mn atoms in high valence states, surface-adsorbed oxygen, and oxygen lattice defects in the catalyst are the most important factors affecting the performance of the catalyst. The performance test results showed that the optimal pyrolysis temperature of sludge was 400 °C, the optimal dosing ratio of Co and Mn was 4:1, and the catalyst achieved 42.98% and 52.41% conversion of acetone and NO, respectively, at 240 °C with UV irradiation. Compared with the pure SBC without catalytic effect, the SBC loaded with Co and Mn gained the ability of simultaneous removal of acetone and NO through the combined effect of multiple factors. The key reaction steps for the catalytic conversion of acetone and NO on the catalyst surface were investigated according to the Mars-van Krevelen (MvK) mechanism, and a possible mechanism was proposed. This study provides a new strategy for the resource utilization of sewage sludge and the preparation of photothermal catalysts for the simultaneous removal of acetone and NO at low cost.