Abstract
ABSTRACTRecently, as a result of developments in microelectromechanical systems (MEMS) technology, various studies have been conducted to perform positioning by combining low-cost MEMS-based IMUs and the GNSS. The advantage of MEMS IMU is its low cost; however, its limitation is that the navigation error rapidly increases when disconnected from the GNSS. Therefore, precise positioning is difficult in tunnels or urban environments, where GNSS signals are unreliable. For this reason, additional sensors are needed. In this study, we intend to improve the accuracy of existing GNSS/IMU couplings using internal sensors and a magnetometer (MAG) attached to a vehicle.In this study, a positioning algorithm is developed based on the extended Kalman filter using on-board vehicle sensors and a MAG in addition to GNSS/IMU. A wheel speed sensor (WSS) and yaw rate sensor (YRS) were used as the on-board vehicle sensors. Experimental data were acquired and performance was analyzed. The results show that the GNSS/MEMS-IMU/WSS/YRS/MAG combination has the most stable positional accuracy, with a horizontal deviation of about 3.6 m observed in 10 zones of 30-second GNSS signal blockage. The performance was not significantly improved by adding the YRS; however, when the WSS and the MAG were used, the performance was greatly improved in the zones with GNSS signal blockage.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
