Abstract
Flexible electronics and optoelectronics devices attract further attention in recent years. In this paper, we present the fabrication and photodetection properties of a flexible metal-semiconductor-metal UV photodetector based on a thin ZnO film with Pd Schottky electrodes. The active ZnO layer was created using a hydrothermal method on ITO/PET flexible substrates. Palladium employed as back-to-back Schottky contacts. Metal masks are designed and used to deposit palladium via thermal evaporation. To demonstrate the impact of ZnO on flexible substrates, the structural, optical, and electrical characteristics of the produced films were examined and assessed. I-V characteristics under dark and illumination conditions for a device were measured using a voltage range of -2.8 V to 2.8 V. The measured data were used to calculate device parameters and photodetection properties. Such as ideality factor, barrier height, saturation current, detectivity, responsivity, contrast-ratio, and efficiency. The proposed device exhibited a gain (efficiency of 200%} caused by trapping hole carrier at the ZnO-Pd interface.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Journal of Engineering and Sustainable Development
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.