Abstract
Injection Molding is a thermoplastic material processing method in which the material that melts due to heating is injected by a plunger into the mold and then cooled until the material is solid, and removed from the mold.
 
 The purpose of this design is to determine the maximum load that can be accepted by the short bench (Dingklik), and to design the dimensions of the bench, while the design stages are as follows: starting from the design of the bench using CAD/CAE software, and machining simulation using can CAM software.
 
 Data input simulation is performed using the CAM software engine. The maximum weight of the respondent is 95 kg, and the load chosen to be safe in this design is 190 Kg (1862,9 N)
 
 The results of the design of the bench obtained the following data: length 350 mm, width 250 mm and height 180 mm, the material used is Polypropylene, the surface area of the object is 409923 mm2, the total volume with the gatting system is 776493,9461 mm3, and the maximum load that the material can withsatand is 2551.3995 Newtons.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
