Abstract

Thin films of GaN on c-plane sapphire were grown by plasma-enhanced molecular beam epitaxy (PEMBE). The influence of different growth conditions on the quality of the epitaxial layers was studied by x-ray diffraction (XRD), atomic force microscopy (AFM) and Hall measurements. For low deposition temperatures, the growth of a thin buffer layer of AlN results in a decrease of the XRD rocking curve full width at half maximum (FWHM) but also in poorer quality in electronic and optical properties. Samples of 3μm thickness with 570 arcsec FWHM in the XRD rocking curve, a near band gap PL-emission FWHM at 5 K of 7 meV, charge carrier densities of ne = 2 × 1017 cm−3, and Hall mobilities of 270 cm2/Vs at 300 K were grown without a buffer layer. A comparison of the morphology and XRD rocking curves with those of GaN films deposited by metalorganic chemical vapour deposition (MOCVD) shows that the two methods have different growth mechanisms.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.