Abstract
Pectin-based nanoemulsions loaded with itraconazole were prepared using high-pressure homogenizer comparing to sonicator. The high-pressure homogenization provided the smaller size of emulsions when homogenizing time was increased. Using the homogenizing pressure of 100 MPa for 90 minutes could provide nanosized emulsions. Sonication method could reduce the emulsion size, however, the size was limited to approximately 2 µm. The type of pectin also influenced the emulsion size. Using high methoxyl pectin (HMP) provided the smallest emulsion, compared to low methoxyl pectin (LMP) and amidated low methoxyl pectin (ALMP). This may be due to the high portion of hydrophobic moieties of HMP which provides better emulsifying properties. From these results, the high-pressure homogenization could produce the nanosized emulsions. Pectin type significantly influenced the emulsion properties. Therefore, the use of high-pressure homogenization method with the proper emulsifiers could provide the nanosized emulsions.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.