Patternable Gelatin Methacrylate/PEDOT/Polystyrene Sulfonate Microelectrode Coatings for Neuronal Recording.

Abstract

This manuscript addresses the need for new soft biomaterials that can be fabricated on the surface of microelectrodes to reduce the mechanical mismatch between biological tissues and electrodes and improve the performance at the neural interface. By electrochemical polymerization of poly(3,4-dioxythiophene) (PEDOT)/polystyrene sulfonate (PSS) through a gelatin methacrylate (GelMA) hydrogel, we demonstrate the synthesis of a conducting polymer hydrogel (CPH) to meet the performance criteria of bioelectrodes. The hybrid material can be photolithographically patterned and covalently attached to gold microelectrodes, forming an interpenetrating network, as confirmed by infrared spectroscopy. The GelMA/PEDOT/PSS coatings were found to be reversibly electroactive by cyclic voltammetry and had low impedance compared to bare gold and GelMA-coated microelectrodes. The CPH coatings showed impedance at levels similar to conventional PEDOT/PSS coatings at a frequency of 1000 Hz. CPH exhibited electrochemical stability over 1000 CV cycles, and its performance was maintained over 14 days. Biocompatibility of the CPH coatings was confirmed by primary hippocampal neuronal cultures via a neuronal viability assay. The CPH-coated microelectrode arrays (MEAs) successfully recorded neuronal activity from primary hippocampal neuronal cells. The CPH GelMA/PEDOT/PSS is a highly promising coating material to enhance microelectrode performance at the neural interface.