Paths to alternative fuels for aviation

Abstract

Almost the complete amount of jet fuel available on the global market is produced from fossil crude oil being an exhaustible raw material. Furthermore its use is inherently connected with emissions of the greenhouse gas CO2. To cope with this, several processes for the production of alternative aviation fuels were developed including the use of biomass as a renewable feedstock. Since biomass from cultivation farming is in competition with food and fodder production, the preferred raw material would be residues from agriculture and forestry or municipal waste, also microalgae can be used. Independent of the raw material, the conversion of biogenic feedstock into alternative jet fuel is based on microbial, thermal and/or chemical breakdown of larger (bio)-molecules into smaller ones, followed by the catalytic formation of fuel molecules and hydrogenation. An overview on the production of different alternative bio-based jet fuels is given including a survey about producers and capacities, focusing on already certificated bio-based jet fuels. In addition to that, a comparison of fundamental combustion properties between Jet A-1 and different alternative jet fuels is presented: Laminar burning velocities and ignition delay times, each measured for two synthetic jet fuels based on fossil resources (coal-to-liquid—CtL and gas-to-liquid—GtL) as well as for two biofuels (farnesane and an Alcohol-to-Jet fuel—AtJ). Measurements of the burning velocities were performed at a preheat temperature of 473 K and pressures of 1 and 3 bar by variation of the fuel–air-equivalence ratios φ. Ignition delay times were determined for φ-values of 0.5, 1.0, and 2.0, at an initial pressure of about 16 bar and temperatures ranging between 800 and 1700 K. It turns out that with respect to the characteristic combustion properties tested the considered alternative fuels have a combustion behavior similar to Jet A-1.