Path of Co-control of Pollution and Carbon Emissions Reduction in Typical Parks of Pharmaceutical and Health Industry in Beijing

Abstract

The agglomeration of carbon emissions from the pharmaceutical and health industry has been growing gradually in Beijing. Conducting research on the path of co-control of pollution and carbon emission reduction in industrial parks is essential to realize synergy between economic development, pollution reduction, and green low-carbon. Based on the production activity data in 2020 of two typical parks of manufacturing and R&D, we selected six measures for co-control of pollution and carbon emission reduction and set up a synergistic development scenario to explore the collaborative development path of different types of parks. The results showed that： ① The primary carbon emission source in the two parks was energy consumption, such as natural gas and electricity, whereas the major pollution source was from key polluting enterprises. The emissions in the R&D park were significantly lower than those in manufacturing parks, with atmospheric pollutant emissions accounting for 25% of the manufacturing park's emissions. ② Energy structure and intensity, along with pollutant emission reduction measures, contributed 62.6% and 37.4% to pollution and carbon emission reduction for the R&D park and 81.6% and 13.5% for manufacturing park, respectively. ③ Adjusting the energy structure of the park and prioritizing the management of key polluting enterprises could achieve synergistic emission reduction, with the rate of emission reduction primarily reflecting atmospheric pollutants. Reducing energy intensity could also facilitate synergistic emission reduction, with a rapid rate of carbon emission reduction. Optimizing the industrial structure could lead to different degrees of pollution and carbon emissions increasing synergistically or not synergistically, owing to the particularity of the industrial structure of the park. ④ Applying measures to adjust the energy structure and reduce energy intensity and pollutant emissions into the collaborative path should be a priority. The governance scope of key polluting enterprises should be appropriately expanded in manufacturing parks. The synergistic effect of public environmental protection facilities of R&D parks should be focused on, in addition to reducing corporate pollutant emissions. Measures to optimize industrial structure at the park level should be adjusted to local conditions and scientifically guide industrial transformation and the settlement of high-tech enterprises.